تخطَّ إلى المحتوى
TakoAPI
العودة إلى المهارات

wiz-light-control

بواسطة canbirlik

Smart Home & IoT
419التنزيلات وفق ما يذكره clawskills.sh
0المشاهدات
لا إعجاباتسجّل الدخول للإعجاب بهذه المهارة
—لم يُقيَّم بعد
تقييمك

موجز

Controls Wiz smart bulbs (turn on/off, RGB colors, disco mode) via local WiFi.

الوصف

ما الذي تفعله هذه المهارة

Controls Wiz smart bulbs on a local WiFi network by communicating with them directly via IP address. Supports on/off toggling, RGB color changes, and a disco mode with configurable duration. Uses the pywizlight Python library with no cloud dependency or account required.

Communicates directly over the local network, so it works without a Wiz account, cloud service, or third-party hub.

متى تستخدمها

  • Turn off bedroom lights without leaving the desk
  • Set the light to red during a movie for ambiance
  • Run a disco light show during a party for 60 seconds
  • Change light color to blue to signal focus or work time
  • Toggle lights on or off as part of a scheduled routine

مثال على سير العمل

الإدخال

User asks: Turn on disco mode for 30 seconds

الوكيل
  1. 1

    Identifies the Wiz bulb's local IP address on the network

  2. 2

    Verifies the Python virtual environment exists, creating it if needed

  3. 3

    Runs wiz.py with --action disco and --duration 30 targeting the bulb IP

  4. 4

    Confirms the command executed successfully

الإخراج

Wiz bulb enters disco mode with cycling colors for 30 seconds

المتطلبات

  • Wiz smart bulb connected to the local WiFi network
  • Local IP address of the Wiz bulb, found via router admin page or network scanner

التثبيت

clawhub install canbirlik/wiz-light-control

شغّل أمر واجهة سطر الأوامر، أو الصق النص في Claude Code أو Cursor أو Codex أو أي وكيل برمجة تستخدمه.

الروابط