تخطَّ إلى المحتوى
TakoAPI
العودة إلى المهارات

icom-7610

بواسطة morozsm

Smart Home & IoT
319التنزيلات وفق ما يذكره clawskills.sh
2النجوم
0المشاهدات
لا إعجاباتسجّل الدخول للإعجاب بهذه المهارة
—لم يُقيَّم بعد
تقييمك

موجز

Control an Icom IC-7610 transceiver over USB/LAN.

الوصف

ما الذي تفعله هذه المهارة

Controls an Icom IC-7610 transceiver over USB or LAN. Reads and sets frequency, mode, and transmit power, and supports CW keying, beacon loops, and remote power on/off. Built-in safety checks enforce amateur band limits, SWR thresholds, and operator confirmation before any RF transmission.

Auto-detects the active connection method (rigctld LAN, flrig XML-RPC, or direct serial) so the same commands work without reconfiguring when switching setups.

متى تستخدمها

  • Set frequency and mode before a FT8 session on 20m
  • Check S-meter and SWR readings during a contest
  • Run a timed CW beacon on 10m with configurable repeat interval
  • Remotely power the radio on or off from across the house
  • Cap transmit power to 5W for a QRP operating session

مثال على سير العمل

الإدخال

User asks: Send a 3-repeat CW beacon on 14.055 MHz

الوكيل
  1. 1

    Check SWR via rigctl to confirm antenna is within safe limits

  2. 2

    Set VFO frequency to 14055000 Hz

  3. 3

    Confirm frequency falls within the 20m amateur band segment

  4. 4

    Request operator confirmation before keying the transmitter

  5. 5

    Send the CW beacon string 3 times with configured interval between repeats

الإخراج

Beacon transmitted 3 times on 14.055 MHz; SWR and band checks passed, operator confirmed

المتطلبات

  • CALLSIGN environment variable (required for CW and beacon)
  • Hamlib — brew install hamlib
  • wfview app for LAN control (optional) — wfview.org/download

التثبيت

clawhub install morozsm/icom-7610

شغّل أمر واجهة سطر الأوامر، أو الصق النص في Claude Code أو Cursor أو Codex أو أي وكيل برمجة تستخدمه.

الروابط