تخطَّ إلى المحتوى
TakoAPI
العودة إلى المهارات

dyson-cli

بواسطة tmustier

Smart Home & IoT
1.7kالتنزيلات وفق ما يذكره clawskills.sh
5النجوم
0المشاهدات
لا إعجاباتسجّل الدخول للإعجاب بهذه المهارة
—لم يُقيَّم بعد
تقييمك

موجز

Control Dyson air purifiers, fans, and heaters via local MQTT.

الوصف

ما الذي تفعله هذه المهارة

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

متى تستخدمها

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

مثال على سير العمل

الإدخال

User asks: Heat the office to 22 degrees

الوكيل
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

الإخراج

Office Dyson powered on with heating enabled and target temperature set to 22°C

المتطلبات

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

التثبيت

clawhub install tmustier/dyson-cli

شغّل أمر واجهة سطر الأوامر، أو الصق النص في Claude Code أو Cursor أو Codex أو أي وكيل برمجة تستخدمه.

الروابط