wiz-light-control
von canbirlik
Smart Home & IoTKurzbeschreibung
Controls Wiz smart bulbs (turn on/off, RGB colors, disco mode) via local WiFi.
Beschreibung
Was dieser Skill macht
Controls Wiz smart bulbs on a local WiFi network by communicating with them directly via IP address. Supports on/off toggling, RGB color changes, and a disco mode with configurable duration. Uses the pywizlight Python library with no cloud dependency or account required.
Communicates directly over the local network, so it works without a Wiz account, cloud service, or third-party hub.
Wann du ihn einsetzt
- Turn off bedroom lights without leaving the desk
- Set the light to red during a movie for ambiance
- Run a disco light show during a party for 60 seconds
- Change light color to blue to signal focus or work time
- Toggle lights on or off as part of a scheduled routine
Beispiel-Workflow
User asks: Turn on disco mode for 30 seconds
- 1
Identifies the Wiz bulb's local IP address on the network
- 2
Verifies the Python virtual environment exists, creating it if needed
- 3
Runs wiz.py with --action disco and --duration 30 targeting the bulb IP
- 4
Confirms the command executed successfully
Wiz bulb enters disco mode with cycling colors for 30 seconds
Voraussetzungen
- Wiz smart bulb connected to the local WiFi network
- Local IP address of the Wiz bulb, found via router admin page or network scanner
Installation
clawhub install canbirlik/wiz-light-controlFühre den CLI-Befehl aus oder füge den Prompt in Claude Code, Cursor, Codex oder deinen Coding-Agenten ein.