Saltar al contenido
TakoAPI
Volver a skills

dyson-cli

por tmustier

Smart Home & IoT
1.7kDescargas según clawskills.sh
5Estrellas
0Vistas
0 me gustaInicia sesión para dar me gusta a esta skill
—Aún sin valoraciones
Tu valoración

Resumen

Control Dyson air purifiers, fans, and heaters via local MQTT.

Descripción

Qué hace esta skill

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

Cuándo usarla

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Flujo de trabajo de ejemplo

ENTRADA

User asks: Heat the office to 22 degrees

AGENTE
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

SALIDA

Office Dyson powered on with heating enabled and target temperature set to 22°C

Requisitos

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Instalación

clawhub install tmustier/dyson-cli

Ejecuta el comando de la CLI o pega el prompt en Claude Code, Cursor, Codex o el agente de programación que uses.

Enlaces