dyson-cli
par tmustier
Smart Home & IoTRésumé
Control Dyson air purifiers, fans, and heaters via local MQTT.
Description
Ce que fait ce skill
Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.
Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.
Quand l'utiliser
- Setting fan to auto speed before leaving the room
- Heating a bedroom to a specific temperature before sleep
- Checking current room temperature and humidity
- Enabling night mode for quiet overnight operation
- Controlling multiple Dyson devices by name from one terminal
Exemple de workflow
User asks: Heat the office to 22 degrees
- 1
Run dyson list --check to confirm device is reachable on the network
- 2
Run dyson on -d "Office" to power on the device
- 3
Run dyson heat on -d "Office" to enable heating mode
- 4
Run dyson heat target 22 -d "Office" to set the target temperature
Office Dyson powered on with heating enabled and target temperature set to 22°C
Prérequis
- dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
- Dyson device credentials configured via dyson setup
Installation
clawhub install tmustier/dyson-cliExécute la commande CLI, ou colle l'instruction dans Claude Code, Cursor, Codex ou l'agent de code que tu utilises.