कंटेंट पर जाएँ
TakoAPI
स्किल्स पर वापस

wiz-light-control

canbirlik द्वारा

Smart Home & IoT
419clawskills.sh द्वारा बताए गए डाउनलोड
0व्यूज़
0 लाइकइस स्किल को लाइक करने के लिए साइन इन करें
—अभी तक कोई रेटिंग नहीं
आपकी रेटिंग

संक्षिप्त

Controls Wiz smart bulbs (turn on/off, RGB colors, disco mode) via local WiFi.

विवरण

यह स्किल क्या करती है

Controls Wiz smart bulbs on a local WiFi network by communicating with them directly via IP address. Supports on/off toggling, RGB color changes, and a disco mode with configurable duration. Uses the pywizlight Python library with no cloud dependency or account required.

Communicates directly over the local network, so it works without a Wiz account, cloud service, or third-party hub.

इसे कब इस्तेमाल करें

  • Turn off bedroom lights without leaving the desk
  • Set the light to red during a movie for ambiance
  • Run a disco light show during a party for 60 seconds
  • Change light color to blue to signal focus or work time
  • Toggle lights on or off as part of a scheduled routine

उदाहरण वर्कफ़्लो

इनपुट

User asks: Turn on disco mode for 30 seconds

एजेंट
  1. 1

    Identifies the Wiz bulb's local IP address on the network

  2. 2

    Verifies the Python virtual environment exists, creating it if needed

  3. 3

    Runs wiz.py with --action disco and --duration 30 targeting the bulb IP

  4. 4

    Confirms the command executed successfully

आउटपुट

Wiz bulb enters disco mode with cycling colors for 30 seconds

आवश्यकताएँ

  • Wiz smart bulb connected to the local WiFi network
  • Local IP address of the Wiz bulb, found via router admin page or network scanner

इंस्टॉलेशन

clawhub install canbirlik/wiz-light-control

CLI कमांड चलाएँ, या प्रॉम्प्ट को Claude Code, Cursor, Codex या जो भी कोडिंग एजेंट आप इस्तेमाल करते हैं उसमें पेस्ट करें।

लिंक