कंटेंट पर जाएँ
TakoAPI
स्किल्स पर वापस

argus-edge

jamierossouw द्वारा

CLI Utilities
420clawskills.sh द्वारा बताए गए डाउनलोड
0व्यूज़
0 लाइकइस स्किल को लाइक करने के लिए साइन इन करें
—अभी तक कोई रेटिंग नहीं
आपकी रेटिंग

संक्षिप्त

Argus-style prediction market edge detection and betting strategy.

विवरण

यह स्किल क्या करती है

Argus Edge is a prediction market betting engine for Polymarket that computes expected value by comparing TA-implied win probability against market odds. It sizes bets using the Kelly criterion and applies freshness and consensus filters to avoid low-signal markets. Derived from 100+ live bets with documented lessons.

Combines TA signal calibration per asset with freshness and consensus guards, filtering out dead signals that a naive EV calculator would still bet on.

इसे कब इस्तेमाल करें

  • Finding high-EV bets on Polymarket before a market matures
  • Sizing a crypto prediction market position with Kelly criterion
  • Scanning all active Polymarket markets for edge above 10%
  • Fading crowd consensus when TA signals diverge from market odds
  • Calculating per-asset bet thresholds for BTC, ETH, SOL, or XRP

उदाहरण वर्कफ़्लो

इनपुट

User asks: Use argus-edge for full market scan with Kelly sizing

एजेंट
  1. 1

    Fetches active Polymarket markets and filters out those older than 30 minutes

  2. 2

    Computes TA score for each relevant asset using asset-specific reliability and bias settings

  3. 3

    Calculates edge as TA-implied probability minus market-implied probability

  4. 4

    Skips markets with edge below 10%, consensus above 92%, or TA score below asset minimum

  5. 5

    Returns ranked bets with Kelly stake sizes based on edge and current bankroll

आउटपुट

A ranked list of actionable Polymarket bets with edge percentage, recommended YES/NO side, and Kelly-sized stake amount

आवश्यकताएँ

  • Polymarket account
  • Polymarket API access or market data feed

इंस्टॉलेशन

clawhub install jamierossouw/argus-edge

CLI कमांड चलाएँ, या प्रॉम्प्ट को Claude Code, Cursor, Codex या जो भी कोडिंग एजेंट आप इस्तेमाल करते हैं उसमें पेस्ट करें।

लिंक