कंटेंट पर जाएँ
TakoAPI
स्किल्स पर वापस

dyson-cli

tmustier द्वारा

Smart Home & IoT
1.7kclawskills.sh द्वारा बताए गए डाउनलोड
5स्टार
0व्यूज़
0 लाइकइस स्किल को लाइक करने के लिए साइन इन करें
—अभी तक कोई रेटिंग नहीं
आपकी रेटिंग

संक्षिप्त

Control Dyson air purifiers, fans, and heaters via local MQTT.

विवरण

यह स्किल क्या करती है

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

इसे कब इस्तेमाल करें

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

उदाहरण वर्कफ़्लो

इनपुट

User asks: Heat the office to 22 degrees

एजेंट
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

आउटपुट

Office Dyson powered on with heating enabled and target temperature set to 22°C

आवश्यकताएँ

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

इंस्टॉलेशन

clawhub install tmustier/dyson-cli

CLI कमांड चलाएँ, या प्रॉम्प्ट को Claude Code, Cursor, Codex या जो भी कोडिंग एजेंट आप इस्तेमाल करते हैं उसमें पेस्ट करें।

लिंक