Lewati ke konten
TakoAPI
Kembali ke skill

dyson-cli

oleh tmustier

Smart Home & IoT
1.7kUnduhan dilaporkan oleh clawskills.sh
5Bintang
0Tayangan
0 sukaMasuk untuk menyukai skill ini
—Belum ada penilaian
Penilaian Anda

Ringkasan

Control Dyson air purifiers, fans, and heaters via local MQTT.

Deskripsi

Apa yang Dilakukan Skill Ini

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

Kapan Menggunakannya

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Contoh Alur Kerja

INPUT

User asks: Heat the office to 22 degrees

AGENT
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

OUTPUT

Office Dyson powered on with heating enabled and target temperature set to 22°C

Persyaratan

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Instalasi

clawhub install tmustier/dyson-cli

Jalankan perintah CLI-nya, atau tempel prompt ke Claude Code, Cursor, Codex, atau coding agent apa pun yang Anda pakai.

Tautan