Vai al contenuto
TakoAPI
Torna alle skill

ralph-ultra

di dorukardahan

Coding Agents & IDEs
432Download riportati da clawskills.sh
0Visualizzazioni
0 likeAccedi per mettere like a questa skill
—Non ancora valutato
La tua valutazione

Sintesi

Deep-dive security audit with 1,000 iterations (~4-8 hours)

Descrizione

Cosa fa questa skill

A 1,000-iteration security audit that runs approximately 4-8 hours across 8 structured phases. Each iteration performs one targeted check with a CVSS score, confidence level, and specific remediation. Four expert personas rotate through phases covering OWASP Top 10, authentication, infrastructure, supply chain, and compliance.

Structures 1,000 individual checks into resumable phases with checkpoint saves every 50 iterations, so audits survive context limits without losing progress.

Quando usarla

  • Pre-release security audit before shipping a major version
  • Compliance audit preparation for GDPR or SOC 2 reviews
  • Post-incident investigation of a compromised codebase
  • Deep follow-up after a lighter audit flags suspicious patterns
  • CI/CD pipeline and container security hardening review

Esempio di workflow

INPUT

User asks: Run a full deep security audit before the v2.0 release

AGENT
  1. 1

    Auto-detects stack, git state, Dockerfiles, and CI/CD config in iteration 1

  2. 2

    Runs 100 reconnaissance checks mapping endpoints, auth flows, exposed ports, and undeclared services

  3. 3

    Executes OWASP Top 10 deep dive across iterations 101-250 using a Code Auditor persona

  4. 4

    Audits secrets, JWT configuration, OAuth flows, and rate limiting in phase 3, then container and network security in phase 4

  5. 5

    Saves checkpoint to .ralph-report.md every 50 iterations and generates a scored final report at iteration 1000

OUTPUT

.ralph-report.md with CVSS-scored findings organized by severity, proof-of-concept exploits where applicable, and specific file-level remediation steps

Installazione

clawhub install dorukardahan/ralph-ultra

Esegui il comando CLI oppure incolla il prompt in Claude Code, Cursor, Codex o nell'agente di coding che usi.

Link