Vai al contenuto
TakoAPI
Torna alle skill

dyson-cli

di tmustier

Smart Home & IoT
1.7kDownload riportati da clawskills.sh
5Stelle
0Visualizzazioni
0 likeAccedi per mettere like a questa skill
—Non ancora valutato
La tua valutazione

Sintesi

Control Dyson air purifiers, fans, and heaters via local MQTT.

Descrizione

Cosa fa questa skill

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

Quando usarla

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Esempio di workflow

INPUT

User asks: Heat the office to 22 degrees

AGENT
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

OUTPUT

Office Dyson powered on with heating enabled and target temperature set to 22°C

Requisiti

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Installazione

clawhub install tmustier/dyson-cli

Esegui il comando CLI oppure incolla il prompt in Claude Code, Cursor, Codex o nell'agente di coding che usi.

Link