본문으로 건너뛰기
TakoAPI
스킬로 돌아가기

wiz-light-control

canbirlik 제작

Smart Home & IoT
419clawskills.sh가 보고한 다운로드 수
0조회수
좋아요 0개로그인하면 이 스킬에 좋아요를 누를 수 있습니다
—아직 평가 없음
내 평가

요약

Controls Wiz smart bulbs (turn on/off, RGB colors, disco mode) via local WiFi.

설명

이 스킬이 하는 일

Controls Wiz smart bulbs on a local WiFi network by communicating with them directly via IP address. Supports on/off toggling, RGB color changes, and a disco mode with configurable duration. Uses the pywizlight Python library with no cloud dependency or account required.

Communicates directly over the local network, so it works without a Wiz account, cloud service, or third-party hub.

사용 시점

  • Turn off bedroom lights without leaving the desk
  • Set the light to red during a movie for ambiance
  • Run a disco light show during a party for 60 seconds
  • Change light color to blue to signal focus or work time
  • Toggle lights on or off as part of a scheduled routine

예시 워크플로

입력

User asks: Turn on disco mode for 30 seconds

에이전트
  1. 1

    Identifies the Wiz bulb's local IP address on the network

  2. 2

    Verifies the Python virtual environment exists, creating it if needed

  3. 3

    Runs wiz.py with --action disco and --duration 30 targeting the bulb IP

  4. 4

    Confirms the command executed successfully

출력

Wiz bulb enters disco mode with cycling colors for 30 seconds

요구 사항

  • Wiz smart bulb connected to the local WiFi network
  • Local IP address of the Wiz bulb, found via router admin page or network scanner

설치

clawhub install canbirlik/wiz-light-control

CLI 명령을 실행하거나, 프롬프트를 Claude Code, Cursor, Codex 등 사용하는 코딩 에이전트에 붙여넣으세요.

링크