본문으로 건너뛰기
TakoAPI
스킬로 돌아가기

agent-step-sequencer

gostlightai 제작

Browser & Automation
1.7kclawskills.sh가 보고한 다운로드 수
3스타
0조회수
좋아요 0개로그인하면 이 스킬에 좋아요를 누를 수 있습니다
—아직 평가 없음
내 평가

요약

Multi-step scheduler for in-depth agent requests.

설명

이 스킬이 하는 일

Multi-step scheduler that detects when a user request requires sequential actions, proposes a step plan, waits for confirmation, then persists and executes each step. Survives gateway resets by writing state to disk and resuming on the next heartbeat. Handles automatic retries and failure recovery without user intervention.

Persisting state to disk and resuming on heartbeat means a mid-execution gateway reset does not lose progress, unlike single-shot agent calls that fail completely if interrupted.

사용 시점

  • Running a multi-phase research and writing workflow
  • Executing sequential API calls with rate-limit delays between steps
  • Automating multi-file migrations or setup tasks
  • Recovering long-running agent tasks after a connection drop
  • Chaining dependent steps where each step's output feeds the next

예시 워크플로

입력

User asks: Research a topic, write a paper based on the research, then produce an outline of the paper

에이전트
  1. 1

    Detects 3 sequential actions with output dependencies, proposes a 3-step plan and waits for user confirmation

  2. 2

    User confirms; agent asks whether to apply 2-minute delays between steps for rate-limit safety

  3. 3

    Agent persists state.json with step definitions and immediately invokes step-sequencer-check.py

  4. 4

    Runner executes step-1, verifies requiredOutputs exist, marks DONE, and advances to step-2

  5. 5

    Heartbeat re-invokes check script on schedule; if a step is FAILED, runner retries with a troubleshoot prompt

출력

All steps marked DONE; agent posts a summary with paths to all files created during the workflow

요구 사항

  • STEP_AGENT_CMD environment variable (command used to invoke the agent, e.g. openclaw agent --message)

설치

clawhub install gostlightai/agent-step-sequencer

CLI 명령을 실행하거나, 프롬프트를 Claude Code, Cursor, Codex 등 사용하는 코딩 에이전트에 붙여넣으세요.

링크