본문으로 건너뛰기
TakoAPI
스킬로 돌아가기

icom-7610

morozsm 제작

Smart Home & IoT
319clawskills.sh가 보고한 다운로드 수
2스타
0조회수
좋아요 0개로그인하면 이 스킬에 좋아요를 누를 수 있습니다
—아직 평가 없음
내 평가

요약

Control an Icom IC-7610 transceiver over USB/LAN.

설명

이 스킬이 하는 일

Controls an Icom IC-7610 transceiver over USB or LAN. Reads and sets frequency, mode, and transmit power, and supports CW keying, beacon loops, and remote power on/off. Built-in safety checks enforce amateur band limits, SWR thresholds, and operator confirmation before any RF transmission.

Auto-detects the active connection method (rigctld LAN, flrig XML-RPC, or direct serial) so the same commands work without reconfiguring when switching setups.

사용 시점

  • Set frequency and mode before a FT8 session on 20m
  • Check S-meter and SWR readings during a contest
  • Run a timed CW beacon on 10m with configurable repeat interval
  • Remotely power the radio on or off from across the house
  • Cap transmit power to 5W for a QRP operating session

예시 워크플로

입력

User asks: Send a 3-repeat CW beacon on 14.055 MHz

에이전트
  1. 1

    Check SWR via rigctl to confirm antenna is within safe limits

  2. 2

    Set VFO frequency to 14055000 Hz

  3. 3

    Confirm frequency falls within the 20m amateur band segment

  4. 4

    Request operator confirmation before keying the transmitter

  5. 5

    Send the CW beacon string 3 times with configured interval between repeats

출력

Beacon transmitted 3 times on 14.055 MHz; SWR and band checks passed, operator confirmed

요구 사항

  • CALLSIGN environment variable (required for CW and beacon)
  • Hamlib — brew install hamlib
  • wfview app for LAN control (optional) — wfview.org/download

설치

clawhub install morozsm/icom-7610

CLI 명령을 실행하거나, 프롬프트를 Claude Code, Cursor, Codex 등 사용하는 코딩 에이전트에 붙여넣으세요.

링크