본문으로 건너뛰기
TakoAPI
스킬로 돌아가기

dyson-cli

tmustier 제작

Smart Home & IoT
1.7kclawskills.sh가 보고한 다운로드 수
5스타
0조회수
좋아요 0개로그인하면 이 스킬에 좋아요를 누를 수 있습니다
—아직 평가 없음
내 평가

요약

Control Dyson air purifiers, fans, and heaters via local MQTT.

설명

이 스킬이 하는 일

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

사용 시점

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

예시 워크플로

입력

User asks: Heat the office to 22 degrees

에이전트
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

출력

Office Dyson powered on with heating enabled and target temperature set to 22°C

요구 사항

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

설치

clawhub install tmustier/dyson-cli

CLI 명령을 실행하거나, 프롬프트를 Claude Code, Cursor, Codex 등 사용하는 코딩 에이전트에 붙여넣으세요.

링크