Перейти к содержимому
TakoAPI
Назад к навыкам

dyson-cli

от tmustier

Smart Home & IoT
1.7kЧисло загрузок по данным clawskills.sh
5Звёзды
0Просмотры
0 лайковВойдите, чтобы поставить лайк навыку
—Ещё нет оценок
Ваша оценка

Кратко

Control Dyson air purifiers, fans, and heaters via local MQTT.

Описание

Что делает этот навык

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

Когда его использовать

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Пример сценария

ВВОД

User asks: Heat the office to 22 degrees

АГЕНТ
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

ВЫВОД

Office Dyson powered on with heating enabled and target temperature set to 22°C

Требования

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Установка

clawhub install tmustier/dyson-cli

Выполните команду CLI или вставьте промпт в Claude Code, Cursor, Codex — любой кодинг-агент, которым пользуетесь.

Ссылки