Skip to content
TakoAPI
Back to skills

icom-7610

by morozsm

Smart Home & IoT
319Downloads reported by clawskills.sh
2Stars
0Views
0 likesSign in to like this skill
—Not yet rated
Your rating

Brief

Control an Icom IC-7610 transceiver over USB/LAN.

Description

What This Skill Does

Controls an Icom IC-7610 transceiver over USB or LAN. Reads and sets frequency, mode, and transmit power, and supports CW keying, beacon loops, and remote power on/off. Built-in safety checks enforce amateur band limits, SWR thresholds, and operator confirmation before any RF transmission.

Auto-detects the active connection method (rigctld LAN, flrig XML-RPC, or direct serial) so the same commands work without reconfiguring when switching setups.

When to Use It

  • Set frequency and mode before a FT8 session on 20m
  • Check S-meter and SWR readings during a contest
  • Run a timed CW beacon on 10m with configurable repeat interval
  • Remotely power the radio on or off from across the house
  • Cap transmit power to 5W for a QRP operating session

Example Workflow

INPUT

User asks: Send a 3-repeat CW beacon on 14.055 MHz

AGENT
  1. 1

    Check SWR via rigctl to confirm antenna is within safe limits

  2. 2

    Set VFO frequency to 14055000 Hz

  3. 3

    Confirm frequency falls within the 20m amateur band segment

  4. 4

    Request operator confirmation before keying the transmitter

  5. 5

    Send the CW beacon string 3 times with configured interval between repeats

OUTPUT

Beacon transmitted 3 times on 14.055 MHz; SWR and band checks passed, operator confirmed

Requirements

  • CALLSIGN environment variable (required for CW and beacon)
  • Hamlib — brew install hamlib
  • wfview app for LAN control (optional) — wfview.org/download

Installation

clawhub install morozsm/icom-7610

Run the CLI command, or paste the prompt into Claude Code, Cursor, Codex or whichever coding agent you use.

Links