Skip to content
TakoAPI
Back to skills

dyson-cli

by tmustier

Smart Home & IoT
1.7kDownloads reported by clawskills.sh
5Stars
0Views
0 likesSign in to like this skill
—Not yet rated
Your rating

Brief

Control Dyson air purifiers, fans, and heaters via local MQTT.

Description

What This Skill Does

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

When to Use It

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Example Workflow

INPUT

User asks: Heat the office to 22 degrees

AGENT
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

OUTPUT

Office Dyson powered on with heating enabled and target temperature set to 22°C

Requirements

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Installation

clawhub install tmustier/dyson-cli

Run the CLI command, or paste the prompt into Claude Code, Cursor, Codex or whichever coding agent you use.

Links