İçeriğe geç
TakoAPI
Becerilere dön

wiz-light-control

canbirlik tarafından

Smart Home & IoT
419İndirme sayıları clawskills.sh tarafından bildirilir
0Görüntülenmeler
0 beğeniBu beceriyi beğenmek için giriş yapın
—Henüz değerlendirilmedi
Puanınız

Özet

Controls Wiz smart bulbs (turn on/off, RGB colors, disco mode) via local WiFi.

Açıklama

Bu Beceri Ne Yapar

Controls Wiz smart bulbs on a local WiFi network by communicating with them directly via IP address. Supports on/off toggling, RGB color changes, and a disco mode with configurable duration. Uses the pywizlight Python library with no cloud dependency or account required.

Communicates directly over the local network, so it works without a Wiz account, cloud service, or third-party hub.

Ne Zaman Kullanılır

  • Turn off bedroom lights without leaving the desk
  • Set the light to red during a movie for ambiance
  • Run a disco light show during a party for 60 seconds
  • Change light color to blue to signal focus or work time
  • Toggle lights on or off as part of a scheduled routine

Örnek İş Akışı

GİRİŞ

User asks: Turn on disco mode for 30 seconds

AJAN
  1. 1

    Identifies the Wiz bulb's local IP address on the network

  2. 2

    Verifies the Python virtual environment exists, creating it if needed

  3. 3

    Runs wiz.py with --action disco and --duration 30 targeting the bulb IP

  4. 4

    Confirms the command executed successfully

ÇIKIŞ

Wiz bulb enters disco mode with cycling colors for 30 seconds

Gereksinimler

  • Wiz smart bulb connected to the local WiFi network
  • Local IP address of the Wiz bulb, found via router admin page or network scanner

Kurulum

clawhub install canbirlik/wiz-light-control

CLI komutunu çalıştırın ya da istemi Claude Code, Cursor, Codex veya kullandığınız kodlama ajanına yapıştırın.

Bağlantılar