İçeriğe geç
TakoAPI
Becerilere dön

icom-7610

morozsm tarafından

Smart Home & IoT
319İndirme sayıları clawskills.sh tarafından bildirilir
2Yıldızlar
0Görüntülenmeler
0 beğeniBu beceriyi beğenmek için giriş yapın
—Henüz değerlendirilmedi
Puanınız

Özet

Control an Icom IC-7610 transceiver over USB/LAN.

Açıklama

Bu Beceri Ne Yapar

Controls an Icom IC-7610 transceiver over USB or LAN. Reads and sets frequency, mode, and transmit power, and supports CW keying, beacon loops, and remote power on/off. Built-in safety checks enforce amateur band limits, SWR thresholds, and operator confirmation before any RF transmission.

Auto-detects the active connection method (rigctld LAN, flrig XML-RPC, or direct serial) so the same commands work without reconfiguring when switching setups.

Ne Zaman Kullanılır

  • Set frequency and mode before a FT8 session on 20m
  • Check S-meter and SWR readings during a contest
  • Run a timed CW beacon on 10m with configurable repeat interval
  • Remotely power the radio on or off from across the house
  • Cap transmit power to 5W for a QRP operating session

Örnek İş Akışı

GİRİŞ

User asks: Send a 3-repeat CW beacon on 14.055 MHz

AJAN
  1. 1

    Check SWR via rigctl to confirm antenna is within safe limits

  2. 2

    Set VFO frequency to 14055000 Hz

  3. 3

    Confirm frequency falls within the 20m amateur band segment

  4. 4

    Request operator confirmation before keying the transmitter

  5. 5

    Send the CW beacon string 3 times with configured interval between repeats

ÇIKIŞ

Beacon transmitted 3 times on 14.055 MHz; SWR and band checks passed, operator confirmed

Gereksinimler

  • CALLSIGN environment variable (required for CW and beacon)
  • Hamlib — brew install hamlib
  • wfview app for LAN control (optional) — wfview.org/download

Kurulum

clawhub install morozsm/icom-7610

CLI komutunu çalıştırın ya da istemi Claude Code, Cursor, Codex veya kullandığınız kodlama ajanına yapıştırın.

Bağlantılar