İçeriğe geç
TakoAPI
Becerilere dön

dyson-cli

tmustier tarafından

Smart Home & IoT
1.7kİndirme sayıları clawskills.sh tarafından bildirilir
5Yıldızlar
0Görüntülenmeler
0 beğeniBu beceriyi beğenmek için giriş yapın
—Henüz değerlendirilmedi
Puanınız

Özet

Control Dyson air purifiers, fans, and heaters via local MQTT.

Açıklama

Bu Beceri Ne Yapar

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

Ne Zaman Kullanılır

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Örnek İş Akışı

GİRİŞ

User asks: Heat the office to 22 degrees

AJAN
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

ÇIKIŞ

Office Dyson powered on with heating enabled and target temperature set to 22°C

Gereksinimler

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Kurulum

clawhub install tmustier/dyson-cli

CLI komutunu çalıştırın ya da istemi Claude Code, Cursor, Codex veya kullandığınız kodlama ajanına yapıştırın.

Bağlantılar