Bỏ qua tới nội dung
TakoAPI
Quay lại kỹ năng

dyson-cli

bởi tmustier

Smart Home & IoT
1.7kLượt tải do clawskills.sh công bố
5Sao
0Lượt xem
0 lượt thíchĐăng nhập để thích kỹ năng này
—Chưa có đánh giá
Đánh giá của bạn

Tóm tắt

Control Dyson air purifiers, fans, and heaters via local MQTT.

Mô tả

Kỹ năng này làm gì

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

Khi nào nên dùng

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

Quy trình ví dụ

ĐẦU VÀO

User asks: Heat the office to 22 degrees

AGENT
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

ĐẦU RA

Office Dyson powered on with heating enabled and target temperature set to 22°C

Yêu cầu

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

Cài đặt

clawhub install tmustier/dyson-cli

Chạy lệnh CLI, hoặc dán prompt vào Claude Code, Cursor, Codex hay coding agent bạn đang dùng.

Liên kết