wiz-light-control
由 canbirlik 提供
Smart Home & IoT简介
Controls Wiz smart bulbs (turn on/off, RGB colors, disco mode) via local WiFi.
描述
该技能的功能
Controls Wiz smart bulbs on a local WiFi network by communicating with them directly via IP address. Supports on/off toggling, RGB color changes, and a disco mode with configurable duration. Uses the pywizlight Python library with no cloud dependency or account required.
Communicates directly over the local network, so it works without a Wiz account, cloud service, or third-party hub.
何时使用
- Turn off bedroom lights without leaving the desk
- Set the light to red during a movie for ambiance
- Run a disco light show during a party for 60 seconds
- Change light color to blue to signal focus or work time
- Toggle lights on or off as part of a scheduled routine
示例工作流
User asks: Turn on disco mode for 30 seconds
- 1
Identifies the Wiz bulb's local IP address on the network
- 2
Verifies the Python virtual environment exists, creating it if needed
- 3
Runs wiz.py with --action disco and --duration 30 targeting the bulb IP
- 4
Confirms the command executed successfully
Wiz bulb enters disco mode with cycling colors for 30 seconds
前置要求
- Wiz smart bulb connected to the local WiFi network
- Local IP address of the Wiz bulb, found via router admin page or network scanner
安装
clawhub install canbirlik/wiz-light-control运行 CLI 命令,或把这段提示词粘贴到 Claude Code、Cursor、Codex 或你在用的任意编程智能体里。