dyson-cli
由 tmustier 提供
Smart Home & IoT简介
Control Dyson air purifiers, fans, and heaters via local MQTT.
描述
该技能的功能
Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.
Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.
何时使用
- Setting fan to auto speed before leaving the room
- Heating a bedroom to a specific temperature before sleep
- Checking current room temperature and humidity
- Enabling night mode for quiet overnight operation
- Controlling multiple Dyson devices by name from one terminal
示例工作流
User asks: Heat the office to 22 degrees
- 1
Run dyson list --check to confirm device is reachable on the network
- 2
Run dyson on -d "Office" to power on the device
- 3
Run dyson heat on -d "Office" to enable heating mode
- 4
Run dyson heat target 22 -d "Office" to set the target temperature
Office Dyson powered on with heating enabled and target temperature set to 22°C
前置要求
- dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
- Dyson device credentials configured via dyson setup
安装
clawhub install tmustier/dyson-cli运行 CLI 命令,或把这段提示词粘贴到 Claude Code、Cursor、Codex 或你在用的任意编程智能体里。