本文へスキップ
TakoAPI
スキル一覧に戻る

dyson-cli

tmustier 作

Smart Home & IoT
1.7kダウンロード数はclawskills.shが公開している値です
5スター
0閲覧数
0件のいいねサインインするとこのスキルにいいねできます
—まだ評価がありません
あなたの評価

概要

Control Dyson air purifiers, fans, and heaters via local MQTT.

説明

このスキルでできること

Controls Dyson air purifiers, fans, and heaters from the command line using local MQTT. Works only on the same WiFi network as the device, no cloud required. Supports power, fan speed, oscillation, heat targeting, night mode, and status queries.

Runs entirely over local MQTT without routing commands through Dyson's cloud servers or mobile app.

使いどころ

  • Setting fan to auto speed before leaving the room
  • Heating a bedroom to a specific temperature before sleep
  • Checking current room temperature and humidity
  • Enabling night mode for quiet overnight operation
  • Controlling multiple Dyson devices by name from one terminal

ワークフロー例

入力

User asks: Heat the office to 22 degrees

エージェント
  1. 1

    Run dyson list --check to confirm device is reachable on the network

  2. 2

    Run dyson on -d "Office" to power on the device

  3. 3

    Run dyson heat on -d "Office" to enable heating mode

  4. 4

    Run dyson heat target 22 -d "Office" to set the target temperature

出力

Office Dyson powered on with heating enabled and target temperature set to 22°C

要件

  • dyson-cli installed at ~/dyson-cli with Python venv (see skill README)
  • Dyson device credentials configured via dyson setup

インストール

clawhub install tmustier/dyson-cli

CLIコマンドを実行するか、Claude Code、Cursor、Codexなどお使いのコーディングエージェントにプロンプトを貼り付けてください。

リンク